- #How to use the dell perc h200 config utility how to#
- #How to use the dell perc h200 config utility drivers#
- #How to use the dell perc h200 config utility update#
- #How to use the dell perc h200 config utility driver#
- #How to use the dell perc h200 config utility upgrade#
Always ensure that your data is backed up and secure.If the controller is new, don't connect any drives until you've upgraded the RAID firmware.
#How to use the dell perc h200 config utility upgrade#
It could alternatively happen if the physical drives are moved from one server to another. However, a foreign configuration could also occur when the Intel® RAID Controller is replaced. (This reference is from Appendix B of the corresponding Intel® RAID Software User Guide).
#How to use the dell perc h200 config utility how to#
See How to Silence the Alarm on Intel® RAID Controllers.įirst, a foreign configuration usually refers to a RAID configuration that already exists on a replacement set of drives that you install in a computer system. Consequently, during POST, a Foreign Configuration found message shows up.īecause of this scenario, it's possible the Intel® RAID Controller beeps.
#How to use the dell perc h200 config utility driver#
As a result, both VMware and the partner will support any certified driver when used with a firmware version equal to or higher than the level displayed in the Firmware Version column.See Importing Foreign RAID Arrays on Intel Ctrl+G–based Hardware Intel® RAID Controllers for information on Ctrl+G–based Intel® RAID Controllers.Īrrays that used to work aren't recognized after a power outage or after replacing the RAID card.
#How to use the dell perc h200 config utility update#
We expect that our partners have done extensive testing of a firmware update prior to releasing it. Partners are provided the opportunity to list updated versions in the Additional Firmware column, however, this is not required.VMware does not require partners to recertify their existing certified driver when releasing a firmware update.
VMware policy is to leave the version in the Firmware Version column unchanged. Over time, partners may ship later versions of firmware. The IO Devices section of the VCG lists supported driver and firmware combinations for IO devices.The firmware listed in the Firmware Version column displays the firmware version used at the time of certification. vSAN support requires that users only use the driver and firmware combinations listed on the vSAN VCG.
#How to use the dell perc h200 config utility drivers#
VMware Support Policy for drivers with firmware versions not listed on the VMware Compatibility Guide (VCG) IO Devices section IMPORTANT NOTE: The following information does not apply to vSAN deployments.